Preparing for Use
R&S
®
QAR
32
User Manual 1178.7200.02 ─ 09
Required tools:
●
Torque wrench (order no. 0041.1218.00).
AC Power
LAN
Monitor (DVI + power)
Mouse (USB)
Keyboard (USB)
Transmitter module
(Radome measurements)
R&S QAR
Figure 4-14: Connection overview in a system with optional transmitter module
1. Connect a monitor to the DVI port on the R&S
QAR.
As a power source, you can use a household AC outlet or the integrated power
supply to supply the monitor with power (for monitors with a light-current extension
cable).
Note:
The monitor should have at least a resolution of 1650 x 1050 (we recom-
mend 1920 x 1080). Lower resolutions can lead to an incorrect display of the mea-
surement data.
The BIOS supports monitors with a vertical resolution of up to 1080p.
2. Connect a keyboard and a mouse to two of the USB ports.
3. Optional: Establish a connection to your LAN via the LAN interface.
4. Optional (radome measurements): Connect the transmitter module to the
R&S
QAR via the SMA and transmitter control connectors on both devices.
Tighten the SMA connector to 0.6 Nm with the torque wrench.
5. Connect the R&S
QAR to the mains power supply with the power cord that is part
of the delivery.
Note:
Always connect all devices before connecting the R&S
QAR to the mains
supply.
4.4
Switching the R&S
QAR On and Off
Supplying the R&S
QAR with power
Always complete all connections (LAN, USB etc.) before connecting the R&S
QAR to
the mains supply.
Refer to the datasheet for power rating and electrical safety compliance.
1. Make sure that the protective ground connection is established.
Switching the R&S
QAR On and Off
