RIGOL
User’s Guide for DSA800E Series
3-8
5)
Communication test
Right click the resource name such as
DSA832E (USB0::0x1AB1::0x0960::DSA8A134400008::INSTR)
and
select "SCPI Panel Control" to open the remote control panel from which
you can write commands and read data. For more information about the
SCPI commands, refer to the
DSA800E Programming Guide
.
2.
Remote Control via LAN
1)
Connect the devices
Connect the analyzer to your LAN.
2)
Configure LAN parameters
Select LAN interface according to the description in "LAN" of "
".
3)
Search device resource
Start-up
Ultra Sigma
and click
. Then, click
in
the pop-up window and the software starts searching for the analyzer
resources connected to LAN. When a LAN resource is found, its name will
be displayed in the resource box on the right side of the panel. Select the
desired resource and click
to add the resource.
Note:
The resource selected should keep consistency with the IP address
of the LAN interface of the spectrum analyzer. In addition, if you want to
remove the unwanted resource, click the corresponding resource name
and click
.
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30
