Rigol DSA800E Series, User Manual

Page: 53 / 221

RIGOL Chapter 2 Front Panel Operation
User’s Guide for DSA800E Series
2-4
span would affect other system parameters. For more details, please refer to
"
Span ".

In Zero Span mode, the start frequency, stop frequency and center frequency
are always the same. If one is changed, the others are updated to match.

You can use the numeric keys, the knob, or the arrow keys to modify the
parameter. Refer to "
Parameter Setting
" for more details.
Table 2-2 Start Frequency
Parameter Explanation
Default
0 GHz
Range*
0 Hz to 3.2 GHz
Unit GHz, MHz, kHz, Hz
Knob Step Span > 0, step = Span/200
Span = 0, step = RBW/100
Min = 1 Hz
Arrow Key Step CF step
Note: *The range is from 0 Hz to (3.2 GHz-100 Hz) in non-zero span.
Stop Freq
Set the stop frequency of the current channel. Press this key to switch to start/stop
frequency input mode. The start and stop frequencies are displayed at the lower
left and right sides of the grid respectively.
Key Points:

The span and center frequency vary with the stop frequency. The change of
span would affect other system parameters. For more details, please refer to
"
Span ".

In Zero Span mode, the start frequency, stop frequency and center frequency
are always the same. If one is changed, the others are updated to match.

You can use the numeric keys, the knob, or the arrow keys to modify the
parameter. For more details, please refer to "
Parameter Setting ".
www.calcert.com sales@calcert.com 1.800.544.2843
0
5
10
15
20
25
30