BIT SWITCHES
14 June, 2002
5-32
System Switch 0A
No FUNCTION
COMMENTS
0-1
Line type selection
Bit 1 Bit 0 Setting
0 0 G3
0 1 PABX
1 0 G4
1 1 Not used
Determines the machine’s default standby line for
transmission.
2
Not used
Do not change these settings.
3
Continuous polling reception
0:
Disabled
1:
Enabled
This feature allows a series of stations to be polled
in a continuous cycle.
4
Dialing on the ten-key pad when
the handset is off-hook
0:
Disabled
1:
Enabled
1:
The user can dial on the ten-key pad when the
handset is off-hook.
5
On-hook dial
0:
Disabled
1:
Enabled
0:
On-hook dial is disabled.
6
Line used for G3 transmission
0:
PSTN
1:
ISDN
If an ISDN kit has been installed, this bit
determines whether G3 transmissions go out over
the PSTN or the ISDN.
7
Line used when the machine
falls back from G4 to G3if the
other end is not a G4 machine
0:
PSTN
1:
ISDN
This bit switch has no effect if Communication
Switch 07 bit 0 is set to 0.
System Switch 0B
No FUNCTION
COMMENTS
0-1
Not used
Do not change these settings.
2
3
Energy Saver mode timer
Bit 3 Bit 2 Time Limit
0 0 1 minute
0 1 3 minutes
1 0 5 minutes
1 1 No limit
(1, 1):
Automatic Energy Saver mode is disabled.
(Other):
The machine goes into Energy Saver
mode when the timer expires after the last
operation.
4
Not used
Do not change these settings.
5-6
LCD back light timer
Bit 6 Bit 5 Timer
0 0 10 seconds
0 1 20 seconds
1 0 30 seconds
1 1 No limit
If set to 10 s, the back light will go out 10 s after
the user finished using the operation panel.
If set to ‘no limit’, the back light never goes out.
7
Key to be pressed to exit energy
saver mode
0:
Only the energy saver key
1:
Any key
1:
Any key can be pressed to exit energy saver
mode
