Ricoh PENTAX K-3, Service Manual

Page: 104 / 318

ERROR CODES 14 June, 2002
4-28
Code Meaning Suggested Cause/Action
2-30 JPEG initializing error
2-31 JPEG compression error
2-32
JPEG – FCU handshake
error
Replace the JPEG unit.
Replace the FCU.
2-50 The machine reset itself If this is frequent, replace the FCU.
2-51
Fail safe timer runs out while
communication Replace the FCU.
2-52
Memory resource releasing
error after communication Check the connection between FCU, optional SG3
and optional NCU board.
2-53 Soft reset occurred Replace the FCU
3-00 G4 interface board reset Replace the G4 interface board or FCU.
3-01 SG3 interrupt error
3-02 SG3 response error
Replace the SG3 board or FCU
3-10
Disconnection during ISDN
G3 communication Check the other terminal and the ISDN line.
The other terminal may dialed a wrong number.
3-11
Disconnection during ISDN
G4 communication Check the other terminal and the ISDN line.
3-20
A SAC signal was received
during ISDN G4
communication The operator at the other terminal may have
interrupted the communication.
3-21
A CSA was sent during
ISDN G4 communication,
because the Stop key was
pressed The local operator has interrupted the
communication.
3-30
Mismatched specifications
(rx capability) Check the receive capabilities requested from the
other terminal.
4-00
One page took longer than 8
minutes to transmit Check for a bad line.
Try the communication at a lower resolution, or
without halftone.
Change the FCU.
4-01
Line current was cut Check the line connector.
Check the connection between FCU and NCU.
Check for line problems.
Replace the FCU or the NCU.
4-10
Communication failed
because of ID Code
mismatch (Closed Network)
or Tel. No./CSI mismatch
(Protection against Wrong
Connections) Get the ID Codes the same and/or the CSIs
programmed correctly, then resend.
The machine at the other end may be defective.
5-00
Data reconstruction not
possible Replace the FCU.
5-10 DCR timer expired Replace the FCU.
5-20
Storage impossible because
of a lack of memory
5-21 Memory overflow
Temporary memory shortage.
Test the SAF memory.
Replace the FCU board
5-22
Mode table overflow after
the second page of a
scanned document Wait for the messages which are currently in the
memory to be sent or delete some files from
memory.