Ricoh LD520CL, Operating Instructions Manual

Page: 797 / 956

Deleting specified IPv4 destination from Routing Table
msh> route delete {host|net} “destination”
• If you do not specify {host|net}, the host setting is automatically selected.
• IPv4 address of destination can be specified.
Setting IPv6 Default Gateway
msh> route add6 default gateway
Adding a specified IPv6 destination to Routing Table
msh> route add6 “destination” “prefixlen[1-128]” “gateway”
• Specify the IPv6 address to destination and gateway.
• If the prefix of the address is between 1 and 127, the network is selected. If the prefix of the
address is 128, the host is selected.
• You cannot register a record that has the same destination and prefix as a registered record.
• You cannot register a record that uses “0000:0000:0000:0000:0000:0000:0000:0000” as
its destination.
Deleting a specified IPv6 destination from Routing Table
msh> route delete6 “destination” “prefixlen”
• Specify the IPv6 address to destination and gateway.
Display information about a specified IPv6 route information
msh> route get6 “destination”
• Specify the IPv6 address to destination and gateway.
Enabling/disabling a specified IPv6 destination
msh> route active6 “destination” “prefixlen[1-128]” {on|off}
Route initialization
msh> route flush
• The maximum number of IPv4 routing tables is 16.
• The maximum number of IPv6 routing tables is 2.
• Set a gateway address when communicating with devices on an external network.
• The same gateway address is shared by all interfaces.
• “Prefixlen” is a number between 1 and 128.
rhpp
Use the “rhpp” command to view and configure RHPP settings.
Remote Maintenance by telnet
127
4