Ricoh G104, Service Manual

Page: 81 / 601

ADJUSTMENTS
SM 3-31 G104
R
ep
lac
em
en
t
Adjus
tm
ent
You can adjust 15 points for each color: (example [A]) between 0 (lowest density)
[B] and 255 (highest density) [C]. For each point, you can adjust the density within
0 and 255.
The gradation scales marked ‘Default’ are printed according to the default gamma
settings in the flash ROM in the controller. The gamma adjustment changes the
densities at the adjustable points in the gradation scale. The gradation scale
marked “Current” shows the current settings.
Compare the “Current” gradation scale with the ‘Default’ at the time you perform
the adjustment procedure. Select the density for each of the 15 adjustable points,
excluding points 0 and 255, from the ‘Default’ gradation scale.
The NVRAM holds three sets of controller gamma settings:
•
Those saved this time: Controller SP 1101 ToneCtlSet - Tone (Current)
•
Those saved in the previous adjustment: Controller SP 1101 ToneCtlSet -
Tone (Prev)
•
The factory settings: Controller SP 1101 ToneCtlSet - Tone (Factory).
Adjustment Procedure
1. Enter the controller service mode. ( 5.1.1)
2. Use the down arrow key to select Controller SP 1102 “ToneCtlSet”. Then press
the Enter key.
3. Use the up/down key to select the mode you want to calibrate, Then press the
Escape key until you get back to the controller service mode menu.
4. Use the down arrow key to select Controller SP 1103 “PrnColorSheet”. Then
press the Enter key.
5. Use the up/down key to select Controller SP 1103 001 “ToneCtlSheet”
(normally this is displayed by default). Then press the Enter key.
6. Press the Enter key to print out the “color calibration test sheet”. When
“Execute?” shows.
7. Press the Escape key 2 times to exit from the menu. (You return to Controller
SP 1103 “PrnColorSheet” in the controller service menu.)
8. Use the down arrow key to select Controller SP 1104 “ToneCtlValue”. Then
press the enter key.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA