Ricoh G104, Service Manual

Page: 125 / 601

SERVICE MODE TABLE
SM 5-9 G104
Service
Tables
5.2.2 BIT SWITCH PROGRAMMING
Do not change the bit switches unless you are told to do this by the manufacturer.
1. Start the SP mode. The “Service” menu is shown.
2. Press the enter key two times.
3. To select a bit switch, press the up arrow key or the down arrow key.
4. Push the enter key.
5. Set the value with these keys:
•
[Up] [Down]:Moves the cursor to one of the adjacent bits.
• [Escape]: Goes out of the program without saving changes.
•
[Enter]: Goes out of the program and saves changes.
NOTE:
The digit at the left [A] is bit 7 and the digit at
the right [B] is bit 0.
6. Push the escape key one or more times until the
menu “Service” is shown.
7. Select “End” and push the enter key.
Sw#1 00000000
bit0 _
[B] [A]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA