Ricoh G104, Service Manual

Page: 218 / 601

FIRMWARE UPDATE
G104 5-102 SM
5.3.4 UPDATING
Procedure
Before beginning this procedure, print a
configuration page.
1. Turn off the main power switch.
2. Disconnect the printer from the
network ( 5.3.2).
3. Remove the slot cover from slot 3 (

x 1).
NOTE:
Do not use the slot 2. The slot 2 is for customer use.
4. Turn the SD card face to the rear side of the printer, and insert it into slot 3.
5. Slowly push the SD card into the slot until it clicks.
6. Make sure that the SD card is locked in place.
NOTE:
To remove the SD card, push it in until it clicks, and release it slowly.
The slot pushes out the SD card.
7. Turn on the main power switch.
8. Wait until a firmware name is shown on the display (about 1 minute).
NOTE:
The firmware name is read from within the firmware. The firmware
name will not change even if you change the file name on your PC.
9. If the necessary firmware name is shown on the display, go to the next step. To
use a different firmware, push the up-arrow key or the down-arrow key to find
the necessary firmware.
10. To select the firmware, push the enter key. Make sure that a star (
4
) is next to
the firmware name.
11. If you update more than one firmware program at the same time, find each
firmware and select each of them. Make sure a star is added to each firmware
name.
12. To select “Up Date”, push the up-arrow key or the down-arrow key.
NOTE:
If the customer has used all of three slots, you will need an empty slot for
this procedure. Ask the customer to temporarily remove one of the SD card
in slot 3.
G105S903.WMF
1 2 3
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA