Ricoh G104, Service Manual

Page: 118 / 601

SERVICE PROGRAM MODE
G104 5-2 SM
Accessing the Required Program
Use the “Up/Down arrow” keys to scroll through the menu listing.
1. Service Menu: Controller service modes – Bit Switch 1001 through 1107
( 5.2.2)
2. Engine Maintenance: Engine service modes
•
(Feed) – SP1 001 through SP1 917
•
(Drum) – SP2 101 through SP2 930
•
(Process) – SP3 001 through SP3 821
•
(Mode) – SP5 024 through SP5 990
• (Data Log) – SP7 002 through SP7 936
• (Data Log 2) – SP8 001 through SP8 941
• (Etc.) – SP9 001 through SP9 914
3. End: Exit service mode
To select an item, press the “Enter” key. Then the sub-menu will appear.
Scroll through the sub menu items using the “Up/Down arrow” keys.
To go back to a higher level, press the “Escape” key.
Inputting a Value or Setting for a Service Program
Enter the required program mode as explained above. The setting appearing on
the display is the current setting.
Select the required setting using the “Up/Down arrow” keys, then press the “Enter”
key. The previous value remains if the “Enter” key is not pressed.
Exiting Service Mode
Select “3. End” from the service mode main menu, then press the “Enter” key.
NOTE:
To make some settings effective, turn the main switch off and on after
exiting service mode.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA