Ricoh D391, Service Manual

Page: 65 / 490

6. Hold the inserter [A] behind the bookbinder.
7. Set the keyholes of the hinge plates [B] over the heads of the shoulder screws [C].
8. Slide the inserter forward so the hinge plates slide under the heads of the shoulder screws.
9. Secure the hinges with the hinge screws [D] and [E] (
 x2: M4).
10. Slowly lower the inserter onto the top of the bookbinder.
11. Confirm that positioning pins insert smoothly and completely into holes.
If the positioning pin fits snugly in the hole, no adjustment is necessary.
-or-
If the pin does not insert completely into the hole, do the adjustment procedure described in the next
section.
Adjusting the position of the hinge plate
This procedure is not required if the positioning pin slides freely in and out of the hole when the inserter top
cover is lowered and raised. Do this procedure only if the pin does not move freely out and into the hole
when the inserter top cover is raised and lowered.
1. Raise the inserter.
Inserter-C1 (D391-18) Installation
63
1