Ricoh D391, Service Manual

Page: 355 / 490

5. Perform cover transport from the inserter unit (or bookbinder entrance): 1) Signature transport, 2)
Start cover transport after signature has been stacked.
6. Perform book output: 1) Start binding operation, 2) Glue application, 3) Book trimming Once the
stacking tray returns to the signature turnover position, stacking in the tray can resume.
7. Loop to Step 4 above.
• On the SW2 bank SW1, SW2, SW3 set the finished sizes of the signature and cover, and SW5
sets the transport speed of the signature and cover.
• When [PSW1] is pushed to start signature transport and stacking, the size and speed latch.
• The setting of SW6 on the SW2 bank determines whether the cover is fed from the host machine
or the inserter on top of the bookbinder.
• The cover feed source is enabled at power on and cannot be changed as long as the power
remains on.
8. Turn off the system.
Signature, Cover Finished Size Settings (SW1 to 4 on SW2 Bank)
SW2
Signature Size Cover Size Finished Size
1 2 3 4
* * * * A4 LEF A3 SEF B5
Up * * * - - -
* Up * * A4 LEF (Special) SR A3 (SEF) A4
Up Up * * Exe LEF
279.4 X 378.3 mm
SEF
STMT
* * Up * B5 LEF B4 SEF A5
Up * Up * 9 X 12 in. LEF 13 X 19.2 in. SEF LTR
* Up Up * LTR LEF LTR SEF COM
Up Up Up * A4 LEF A3 SEF COM
* * * Up A4 LEF A3 SEF 203.0 X 283.0 mm
Up * * Up LTR LEF LTR SEF 208.9 X 265.4 mm
* Up * Up - - -
Up Up * Up Exe LEF 279.4 X 378.3 mm 177.1 X 252.7 mm
* * Up Up B5 LEF B4 SEF 175.0 X 243.0 mm
Output Checks
353
4