Ricoh D391, Service Manual

Page: 12 / 490

Field Service Manual Revision History
Field Service Manual Version 2
Perfect Binder Machine Code: D391 Field Service Manual Version 2 Revision History
Section Description
1
Replacement and Adjustment > Common
Procedures > Trimming Unit > Step 6
Replaced with correct photo; photo of the
Signature Transport unit was falsely inserted
instead of the Trimmer unit.
2
Replacement and Adjustment > Common
Procedures > Signature Thickness Sensor
(S50) Recalibration > Steps 10 & 13
LED indication corrected
3
Replacement and Adjustment > Perfect Binder
Boards > When installing a new EEPROM in
Master Control Board
New section added describing the required
adjustments when replacing the EEPROM
4
Replacement and Adjustment > Inserter >
Inserter Control Board
New section added describing the required
adjustments when replacing the Inserter
Control Board (Jam 255)
5
Troubleshooting > Jams > Low Performance
Mode > Cancelling Low Performance Mode
Deleted the procedures described in this
section; refer to "Common Procedures > Setting
and Releasing Low Performance Mode".
6
Troubleshooting > Service Board Basics >
Service Board LEDs
Entire section revised
7
Troubleshooting > Service Mode > Critical
Adjustments
Introduction of the section revised
8
Troubleshooting > Service Mode > Critical
Adjustments > Adjustment 1: Cover Horizontal
Registration Position Adjustment Correction of the paper sizes; Small size less
than 288mm --> 297mm or less, Large size
288mm --> 298mm or more
9
Troubleshooting > Service Mode > Critical
Adjustments > Adjustment 1: Cover Horizontal
Registration Position Adjustment
LED indication corrected; "The LEDs remain
OFF for 2 sec…" --> "The LEDs remain ON for
2 sec…" in the section "How Values of the
Settings Are Displayed"
10