Ricoh A230, Service Manual, Page: 835 / 1134

ERROR CODES
6-4
A230/A231/A232 SM
Code Meaning Suggested Cause/Action
0-22 The signal from the other
end was interrupted for
more than the acceptable
modem carrier drop time
(default: 200 ms)
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Replace the NCU or FCU.
•
Defective remote terminal.
•
Check for line noise or other line problems.
•
Try adjusting the acceptable modem carrier
drop time.
Cross reference
•
Acceptable modem carrier drop time - G3
Switch 0A, bits 0 and 1
0-23 Too many errors during
reception
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Replace the NCU or FCU.
•
Defective remote terminal.
•
Check for line noise or other line problems.
•
Try asking the other end to adjust their tx level.
•
Try adjusting the rx cable equalizer setting
and/or rx error criteria.
Cross reference
•
Rx cable equalizer - G3 Switch 07 (PSTN)
•
Rx error criteria - Communication Switch 02,
bits 0 and 1
0-30 The other terminal did not
reply to NSS(A) in AI short
protocol mode
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Try adjusting the tx level and/or cable equalizer
settings.
•
The other terminal may not be compatible.
Cross reference
•
Dedicated tx parameters - Section 4
0-52 Polarity changed during
communication
•
Check the line connection.
Retry communication.
0-70 Communication mode
specified in CM/JM was not
available.
(V.8 calling and called
terminal)
•
The other terminal did not have a compatible
communication mode (e.g., the other terminal
was a V.34 data modem.)
•
A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
0-74 Calling terminal fell back to
T.30 mode, because it
could not detect ANSam
after sending CI.
•
The calling terminal could not detect ANSam
due to noise, etc.
•
ANSam was too short to detect.
•
Check the line connection and condition.
•
Try making a call to another V.8/V.34 fax.