Ricoh A230, Service Manual, Page: 760 / 1134

Serv
ic
e
Ta
b
le
s
A6
9
3
BIT SWITCHES
4-35
SM A230/A231/A232
Scanner Switch 0C
No FUNCTION COMMENTS
0 Action when an original jam
has occurred while scanning
the original into memory for
memory tx
0: Continues scanning after
recovery
1: Stops scanning and erases
all scanned pages for that job This bit is only effective when parallel memory tx
is disabled (user parameter 07 - bit 2).
If parallel memory tx is enabled, the machine
always erases the scanned pages when an
original jam occurs. The machine then asks the
user to retry from the first page, even if the
parallel memory tx is not actually used.
0: The machine displays a message asking the
user to put the jammed page back into the original
stack, and continues scanning.
The message is displayed for the time period
specified by scanner switch 0E, bit 2.
1: The machine erases all the scanned pages and
asks the user to retry from the first page.
1
to
2
Setting when an original size
cannot be recognized
Bit 2 1 Setting
0 0 Depending on the
copier’s setting
0 1 A5
1 0 A5
1 1 No original
When both bits are set to “0”, the machine
recognizes an original size depending on SP4-
303 copier’s service mode.
3
to
5
Not used Do not change the settings.
6 Scan width used for a
document set in the ADF
when the width is less than
230 mm.
0: A4 (210 mm)
1: LT (216 mm) This bit is set at “1” when the country code is set
to the US.
Refer to Sub Scan Length Correction using ADF
in section 2.
7 Original length adjustment for
A4/LT LEF originals in ADF
scan mode
0: Enable
1: Disable 0: An original of 193 to 223 mm length is
regarded as A4 or LT depending on the setting of
bit 6 above.
1: Original length data from the ADF sensor is
used.
Refer to Sub Scan Length Correction using ADF
in section 2.