Ricoh A-P4, Service Manual

Page: 222 / 381

Prints the communication log.
582
1
Remote Service A Remote Service Address Japan Only
001 CSS-PI Device C(ode)
Sets the PI device code. After you change this setting, you
must turn the machine off and on.
002 RCG IP Address
Sets the IP address of the RCG (Remote Communication
Gate) destination for call processing at the remote service
center.
[00000000h~FFFFFFFFh/1]
5824 NVRAM Upload
Uploads the UP and SP mode data (except for counters and the serial number) from NVRAM
on the control board to an SD card
Note: While using this SP mode, always keep the front cover open. This prevents a software
module accessing the NVRAM during the upload.
5825 NVRAM Download
Downloads data from an SD card to the NVRAM in the machine. After downloading is com-
pleted, remove the card and turn the machine power off and on.
5828 Network
This machine supports both Internet Protocols IPv4 and IPv6. IPv6 is the next generation protocol
designed by the IETF to replace IPV4. IPv6 adds many improvements such as routing and network
auto-configuration.
001 IPv4 Address
This SP allows you to confirm and reset the IPv4 address for
Ethernet and a wireless LAN (802.11b):
aaa.bbb.ccc.ddd
For example, if the 8-bit entry is "192.168.000.001" this is
read "0C0A80001h"
002 IPv4 Subnet Mask
This SP allows you to confirm and reset the IPv4 subnet mask
for Ethernet and a wireless LAN (802.11b):
aaa.bbb.ccc.ddd
Service Program Mode Tables
221
5