Raven Envizio Pro, Installation And Operation Manual

Page: 148 / 287

P/N 016-0171-493 Rev. I 133
Tools Menu
7
Source
Important:
If a SmarTrax assisted steering system is connected to the Envizio Pro field computer, set the correction
source to internal before making changes to the Envizio Pro internal receiver.
The GPS Source screen allows the operator to select
between the internal GPS receiver or an optional
external receiver such as a Raven Phoenix 200/300.
Note:
The GPS Source screen is only available on
field computers with the internal DGPS receiver.
The GPS Source screen also displays an option to
automatically setup the output messages from the
built-in receiver to route through an optional TM-1 Tilt
Module or SmarTrax system.
Internal GPS Receiver
To use the internal receiver, select the ‘Internal GPS
Receiver’ option. Verify settings on the GPS Output
screen to ensure that any required messages are properly configured.
Via TM-1 or SmarTrax™
Important:
If a SmarTrax assisted steering system is connected to the Envizio Pro field computer, set the correction
source to internal before making changes to the Envizio Pro internal receiver.
To output DGPS signal from the built-in receiver to an optional TM-1 Tilt Sensor or SmarTrax controller, select
the Internal GPS Receiver (Via Tilt or SmarTrax) option.
Note:
The GPS Output Baud must be set to 19,200 before selecting the Via TM-1 or SmarTrax option
(see the External Light Bar, TM-1 Tilt Module and SmarTrax™ section on page 132). Do not select
the this option if the optional hardware components are not connected. The field computer may
take several minutes to properly setup these components or may lock up if the
TM-1 or SmarTrax controller are not connected.
This option requires additional cables to route DGPS signal from the internal receiver out to the
TM-1 or SmarTrax controller and then back into the field computer. Review the installation sections
for these optional system components or contact a local Raven dealer for more information.
External GPS Receiver
If an optional external GPS receiver is connected to the field computer via the connector labeled ‘DGPS’ on the
main interface cable (P/N 115-0171-746) or chassis interface cable (P/N 115-0172-001) select the External
Receiver option. Selecting this option overrides the internal DGPS receiver.