74-07579-000-A 2/96
Page 22
© 1996 Radionics, Inc.
Setting the Clock
This item sets the clock that the EK1000 uses for Time Profiles and the time
stamp for printed reports.
Checking the clock and calendar regularly is important when using Time Profiles,
or if you are using the printer to log events. Use the following procedure for
setting the clock:
If at any point you enter an invalid value, like 15 for the month, you will get a long
beep and the original value re-displayed.
If the date is invalid, for example 02/31/95, then you will be returned to the year
value in Step 4 in the procedure below. Re-enter the correct month and date.
Step
Example
Display
Action
1
Present an Editor Key/Card to the EK100's internal
reader.
2
SEL?
Press
INST/9
3
SetC
Press
SEL/SAVE
4
Yr95
Type the new year value (e.g. 95) and press
SEL/SAVE
. Press to move to the next item.
5
Mt05
Type the new month value (e.g. 05) and press
SEL/SAVE
. Press to move to the next item.
6
Dt06
Type the new date value (e.g. 06) and press
SEL/SAVE
.
7
Dy2
Type the day of the week, Mon=1, Tue=2, Wed=3,
Thu=4, Fri=5, Sat=6, Sun=7, (e.g. 2=Tuesday) and
press
SEL/SAVE
. Press to move to the next
item.
8
Hr11
Type the hour and press
SEL/SAVE
. Press to
move to the next item. Note: Use military time
entries (e.g. 6:00 p.m. = 18:00 Hours).
9
Mn08
Type the minute (e.g. 08) and press
SEL/SAVE
.
The clock is now set. Press
ESC
.
10
SEL?
Press
ESC
to leave the Editor.
Change the time for Daylight Savings Time:
The EK1000 follows a true
calendar year and recognizes leap year, but does not observe Daylight Savings
Time so you may need to make local time adjustments for Daylight Savings
Time.
