Initializing the Storage Arrays and Software
43
DXi6902
9
Verify that the number of Array Modules detected is correct, then type
y
and press
<Enter>
.
The system begins background RAID initialization of the storage arrays (see
). Starting background RAID initialization can take several minutes.
Figure 40 PTO: RAID Initialize
Verifing storage...
Verification check : PASS
Checking if all RBOD's firmware is upto-date...
All Firmware OK.
Proceeding to generate the SMcli script files...
Disabling AVT and Parity repair on the array Qarray1
AVT and Parity repair disabled on the array Qarray1
Generating array configuration script for Qarray1
Clearing out old configuration from Qarray1...
Deleting the existing configuration.
Deleting all Volumes and Pools.
Set controller in duplex mode.
Setting the Storage Array user label to Qarray1.
Set controller default networking.
Done with Qarray1
Starting RAID setup script for Qarray1...
Enabling IAF support.
Disable AVT in controller A
Disable AVT in controller B
Disable Parity Repair, enable fail on PFA
Created Disk_Pool_99
Reserved space for 1 hotspares in Disk_Pool_99
create TRAY_99_VOL_1 of size 15.756 TiB
Creating TRAY_99_VOL_1
Setting additional attributes for Volume TRAY_99_VOL_1.
create TRAY_99_VOL_2 of size 15.756 TiB
Creating TRAY_99_VOL_2
Setting additional attributes for Volume TRAY_99_VOL_2.
Created Disk_Pool_0
Reserved space for 1 hotspares in Disk_Pool_0
create TRAY_0_VOL_1 of size 15.756 TiB
Creating TRAY_0_VOL_1