Installing the DXi6902 System in the Rack
25
DXi6902
Figure 18 DXi6902 Array or
Expansion Module Rails
Installation
Installing the DXi6902 Array or Expansion Module
WARNING:
The DXi6902 Array module and Expansion module (including hard drives)
weigh 59.0 pounds (26.8 kg) and 57.0 pounds (25.9 kg) respectively. A
minimum of two people are required to lift the chassis.
Caution:
Before proceeding, ensure that all hard drive latches are completely closed.
Quantum recommends that you do not remove the hard drives from the
chassis. If they have been removed for any reason during or after the
installation, you
must
install the hard drives in the same position in which
they were removed.
1
Align the Array or Expansion module with the rails, and then slide the module into
).
2
Use a 10-32 x 3/4 in. SEM screw with washer at the bottom hole on each side of the
Array or Expansion module’s front panel to secure the module to the rack.
Rail front end
Rail back end
Latches click into place in rack flange
(round or square holes)
Latch release button
