Quantum DXi6902, Installation And Configuration Manual

Page: 43 / 64

Initializing the Storage Arrays and Software 41
DXi6902
Figure 36 PTO: Hardware
Check Menu
3 On the Hardware Check Menu , type the option for Check Memory and press
<Enter> .
The system displays information about the installed memory (see Figure 37 ).
Make sure the memory configuration is valid before continuing (see Table 1 ). If the
memory configuration is not correct, resolve the issue before continuing (see
Troubleshooting on page 61).
Figure 37 PTO: Check Memory
4 On the Hardware Check Menu , type the option for Check NetApp Trays and press
<Enter> .
The system displays information about attached Array Modules (RBODs) and
Expansion Modules (EBODS) (see Figure 38 ).
Make sure all of the installed RBODs and EBODs are detected. If one or more storage
arrays are not detected, resolve the issue before continuing (see Troubleshooting on
page 61).
Figure 38 PTO: Check NetApp
Trays
*** Pick to Order Hardware Check Menu ***
0) Check Memory - check memory size to number of trays.
1) Check NetApp Trays - check for valid tray combinations.
2) Check HBAs - check for valid PCI slots and cards.
Detected Memory size: 129024 MB, (128 GB)
Memory size OK for the attached 2 tray(s) of external storage.
Array: 1
Number Of Disk Drives: 24
Controller: A
Controller: B
EBOD: 0
ESM Canister: A (Left)
ESM Canister: B (Right)
External Storage is OK.