Installing the DXi6902 System in the Rack
27
DXi6902
Removing the Rails
If you need to remove the rails, use a flat head screwdriver to lift the latch release
button on the end piece midpoint and unseat each rail.
Figure 20 Node Rails
Installation
Installing the DXi6902 Node
WARNING:
The DXi6902 Node (including hard drives) weighs 53.0 pounds (24.0 kg).
A minimum of two people are required to lift the chassis.
Caution:
Before proceeding, ensure that all hard drive latches are completely closed.
Quantum recommends that you do not remove the hard drives from the
chassis. If they have been removed for any reason during or after the
installation, you
must
install the hard drives in the same position in which
they were removed.
1
Pull the inner slide rails out of the rack until they lock into place (see
).
2
Locate the rear rail standoff on each side of the system and lower them into the rear
J-slots on the slide assemblies.
Rail front end
Rail back end
Latches click into place in rack flange
(round or square holes)
Latch release button
