Performing Initial Configuration
51
DXi6902
a
Select the
eth1
row in the table. Or, if necessary, click
Add IP
in the
eth1
row to
enable entry in the
IP Address
box.
b
Enter the following network information as provided by your network
administrator (all fields are required):
Caution:
Make sure you enter the correct IP address information and that
you write this information down. If you enter the incorrect IP
address information and reboot, you will not be able to access the
system.
•
IP Address
- The IP address of the DXi6902.
•
Netmask
- The network mask of the DXi6902.
•
Gateway
- The gateway of the DXi6902. (This is usually not the same as the
default gateway.)
c
Select the
Any
check box to allow all traffic types (management, replication, and
data) on the interface.
d
Click
Update
to save the changes you made to the
IP Address
table.
9
Do not make any changes under
IP Address Configuration > Routing Details
unless directed by your network administrator.
Note:
If the DXi needs to communicate with another subnet that is not reachable
using the default gateway, a route must be added under the
Routing
Details
section. (For more information about interface routing, see the
“Network” section in the
Quantum DXi6902 User’s Guide
, 6-68159).
10
Click
Next
to continue.
The
Date & Time
page displays (see
Figure 45 Getting Started
Wizard: Date & Time