Installing Components in the DXi6902 Node
17
DXi6902
To install the memory modules in the DXi6902 Node:
Caution:
Use appropriate ESD precautions, including the use of a grounding strap,
when performing this procedure.
Caution:
Handle the memory modules by the card edges and avoid touching the
components on the memory module.
1
Remove the plastic memory blank from the socket by pressing down and out on the
ejectors on each end of the socket until the memory blank pops out of the socket
(see
). (The plastic memory blanks are recyclable.)
Figure 10 Installing a Memory
Module
2
Align the memory module’s edge connector with the alignment key of the memory
module socket, and insert the memory module in the socket.
Note:
The memory module socket has an alignment key that allows you to install
the memory module in the socket in only one way.
3
Press down on the memory module with your thumbs until the ejector latches snap
into a locked position.
4
Repeat steps 1–3 for each memory module.
5
Replace the cooling shroud:
a
Align the tabs on the cooling shroud with the securing slots on the chassis (see
).
Memory module
Ejector latch
Socket alignment key
