QMS 1060E, Operation

Page: 83 / 116

Font Problems
6-23 Troubleshooting
External SCSI Hard Disk Not On Line
n
If
DISK ONLINE
does not appear on the start-up or status page,
check the hard disk cable connections to the hard drive and to the
SCSI interface port on the back of the printer. (See your hard disk
drive documentation for more information.)
n
Is the hard disk turned on? Check that the Power indicator is on.
n
Did you turn on the hard disk before you turned on the printer.
Always turn the hard disk on first, and then turn the printer on.
n
Is the SCSI ID set for one of the reserved positions? Do not use
the reserved positions 7, 8, and 9. Make sure each device on the
SCSI chain has a unique address.
n
Did you terminate a hard disk in the middle of the chain? There
should be only one terminated disk in the chain, and it should
physically be the last disk in the chain. (See your hard disk drive
instructions for more information.)
Font Problems
Can't Download Fonts
If you experience problems with fonts not downloading correctly, the
printer may have run out of memory while downloading the fonts,
macros, or patterns. You can do one of the following to increase
printer memory:
n
Add more printer memory, which automatically increases the Disk
Cache client’s size. See chapter 6, “Printer Options,” of the
Referenc e guide for information on installing SIMMs.
n
Take any memory, if available and not being used by other cli-
ents, and add it to the Administration/Memory/K Mem Disk Cache
client.