QMS 1060E, Operation

Page: 82 / 116

Disk Problems
QMS 1060E Print System Operation 6-22
Printer Resets
Occasionally, Macintosh applications interfere with each other. Appli-
cations send a printer prep file to the printer at the beginning of each
document. Other prep files cannot be sent without resetting the
printer. Monitor your activities to see if there is a correlation between
your use of a certain driver version and the printer resetting. If so,
contact the application developer.
Downloading too many typefaces can overload the printer's memory
and cause the printer to reset. Additional memory (RAM) or an
optional hard disk is available and easily installed. Contact your QMS
vendor for information on RAM upgrades. See chapter 6, “Printer
Options,” of the
Reference guide.
If the printer resets in other circumstances, call your QMS vendor for
service.
Disk Problems
IDE Internal Hard Disk Not On Line
n
If
DISK ONLINE
does not appear on the start-up or status page,
check the IDE-SCSI ribbon cable connection to the IDE-SCSI
board and to the IDE internal hard disk. (See chapter 6, the
“Printer Options” section in
Reference guide for information.)
» Note: If these cable connections are properly seated, then you
may have a defective disk drive or IDE-SCSI board. Contact your
QMS vendor. See the list of phone numbers in appendix A, “QMS
Customer Support.”
n
If your printer has only the standard memory, then you need to
enable disk swapping. See chapter 4, “Printer Configuration,” in
the
Reference guide for information on how to enable this option
through the Administration/Memory/Enable Disk Swap menu.