Introduction
QMS 1060E Print System Operation
4-2
Introduction
Blurred or splotchy prints and paper jams can result from dusty printer
parts. Regular cleaning takes only a few minutes and helps ensure
print quality. Printer parts that require cleaning are the paper pick-up
rollers and the outside surface of the printer.
This chapter describes how to handle and clean the printer.
Handling the Printer
Handle the printer with care to preserve its life. Abuse may cause
damage. Keep the following guidelines in mind:
n
Do not place anything on the top of the printer.
n
Do not place anything on the multipurpose tray except the media
being used for printing.
n
Do not leave the printer open for any length of time, especially in
well-lit places; light may damage the toner cartridge.
n
Wait until the printer has cooled down before covering it with a
dust cover.
n
Lift the printer from the bottom only, using the grips. Make sure
two people are available to lift the printer when moving it.
M
WARNING!
Remember that the media feeders on the bottom of
the printer stack are not attached to the printer. Make sure you lift
the printer by the carrying grips on the bottom-most unit in the
stack. If the top unit is lifted alone, the bottom units could fall off,
causing bodily injury or damage to the printer. If you need to lift
just the top unit, use the grips and make sure it detaches
completely from the cassette below before moving it to the side.
Summary of Contents for 1060E
