QMS 1060E, Operation

Page: 62 / 116

Introduction
QMS 1060E Print System Operation 6-2
Introduction
This chapter offers media jam prevention tips, explains how to remove
media jams, lists and explains many control panel messages, outlines
possible printer and print-quality problems and solutions, and explains
how to place a service call.
Automatic Jam Recovery
With most printers, if a jam occurs, you must remove the jammed
media and then reprint the job. However, the QMS 1060E Print Sys-
tem provides automatic jam recovery, if enabled, through the Admin-
istration/Engine/Page Recovery menu. The option must be set to On
for automatic reprinting of a jammed page to occur. If a media jam
occurs when the Page Recovery option is set to On, remove the
jammed media, and the printing automatically resumes from the page
the printer stopped at when the jam occurred.
» Note: For automatic jam recovery to work, it is necessary to leave the
printer turned on when you remove the jammed media. After the jam
is cleared, open and close the top cover once before printing. Printing
will not resume until you do this.
Clearing Media Jams
Locating Print Media Jams
When print media jams occur, a
PAPER JAM
message displays in the
message window. Frequent jams in any area indicate that area
should be checked, repaired, or cleaned. Repeated jams may also
happen if you are using the wrong weight print media. (See the “Print
Media” section of appendix B, “Technical Specifications,” in the
Refer-
ence guide, for print media specifications.)