Qlogic StorageWorks MPX200, User Manual

Page: 75 / 240

2–Command Reference
Command Syntax
ISR654601-00 D 2-51
Set SNMP
Configures the general SNMP properties, as well as configuring eight trap
destinations.
Authority
Admin session
Syntax
set snmp
[trap_destinations [ < DEST_NUM > ]]
Keywords
trap_destinations
Specifies the setting of the trap destinations.
Examples
The following example shows the
set snmp
command for setting the general
properties:
iSR6200 <
1
> (admin) #> set snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP :
-----------------
Read Community [ ] Public
Trap Community [ ] Private
System Location [ ]
System Contact [ ]
Authentication Traps (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be saved.
The following example shows configuring an SNMP trap destination:
iSR6200 <
1
> (admin) #> set snmp trap_destinations
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring SNMP Trap Destination 1 :
-------------------------------------
Destination enabled (0=Enable, 1=Disable) [Disabled ] 0
IP Address [0.0.0.0 ] 10.0.0.5