Qlogic StorageWorks MPX200, User Manual

Page: 38 / 240

2–Command Reference
Command Syntax
2-14 ISR654601-00 D
Window Scaling Factor (Min=0, Max=9) [3 ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
Bandwidth, Mbit/sec (Min=1, Max=10000) [10000 ]
VLAN (0=Enable, 1=Disable) [Disabled ]
FCIP SW Compression(0=Enable,1=Disable,2=Auto)[Disabled ]
All attribute values for FCIP Route 1 will now be saved.
The following shows an example of the
fciproute mod
command:
iSR6200 <1> (admin) #> fciproute mod
A list of attributes with formatting and current values will follow. Enter a
new value or simply press the ENTER key to accept the current value. If you
wish to terminate this process before reaching the end of the list press 'q' or
'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Route FC Port ID GE Port ID
----- ---------- ----------
1 FC1 GE1
Please select a FCIP route from the list above ('q' to quit): 1
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [172.35.15.11 ]
172.35.15.120
Subnet Mask [255.255.254.0 ]
Gateway IP Address [172.35.14.1 ]
Remote IP Address [172.17.136.18 ]
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Enabled ]
Window Scaling Factor (Min=0, Max=9) [7 ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto ]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]
VLAN (0=Enable, 1=Disable) [Disabled ]
FCIP SW Compression(0=Enable,1=Disable,2=Auto) [Auto ]
Do you want to save/discard changes? (0=Save, 1=Discard) [Save ]
All attribute values for FCIP Route 1 will now be saved.