Entering Initial Installation Information
I
52
7. Entering Initial Installation Information
You can use the following procedure to enter the initial installation information and to monitor the operational
information of this system appropriately on server.
7.1 Information Input Administrator
You have to use a laptop or a smart phone to enter the installation information.
7.2 System Information Input Stage
• 1st Step : Direct Connection to PC
→
Input Local Setting Value
• 2nd Step : Connection to Web Page
→
Input Webpage Setting Value
7.3 PC Direct Connection and Local Setting Value
7.3.1 PC Direct Connection Flow
• System Off Status
→
Insert Jumper Wire, Connect PC LAN cable
→
System AC on
→
PC Direct Connection
→
Input Setting Value
→
System off
→
Remove Jumper Wire
→
Connect Internet LAN Cable
7.3.2 LAN Cable Connection between PC and System
7.3.2.1 LAN Cable Type
• UTP cable/category 5E
• 1:1 direct cable
7.3.3 SIM (System Install Manager) Connection
7.3.3.1 Connection
• To enable direct communication between the computer and the Q.HOME+ ESS HYB G2, change
the TCP/IP settings on the computer as shown below :
1. Set on your laptop
[Control Panel
→
Network and Sharing Center
→
Change adapter settings
→
Local Area Connector
→
Properties
→
Internet Protocol Version 4 (TCP/Ipv4)]
IP address: 17.91.23.1
Subnet mask: 255.255.224.0
Default gateway: 17.91.1.2