Purclean PURWATER RECLAIM 3.0, Technical Manual

Page: 87 / 97

Corporate
800.882.8854
87
Ozone Generator LED Display
Figure 11
is
ot
LED Function CD10 CD10/AD CD12 CD12/AD
OZONE The ten LEDs represent 0-100%,
MAX
MAX MAX MAX
OUTPUT minimum to maximum ozone output.
Each LED i s e q u a l t o 1 0 % o u t p u t .
These LEDs can be adjusted with the
manual output control knob located at
the bottom of the ozone generator or
automatically w i t h a remote 4-20mA
OZONE OZONE OZONE OZONE
OUTPUT OUTPUT OUTPUT OUTPUT
control signal.
POWER Main Power is “ON” to the ozone
generator, when LED is illuminated.
HV
DRIVE
EXT
LOOP
Power is being sent to the high voltage
drive board, when the LED is
illuminated.
MIN MIN MIN MIN
The External Loop has continuity
through it when the LED is
n
POWER
HV DRIVE
POWER
HV DRIVE
POWER
HV DRIVE 1
POWER
HV DRIVE 1
ot
EXT LOOP EXT LOOP EXT LOOP HI TEMP 1
illuminated, which indicates ozone is
being p r o d u c e d . The E x t e r n a l
L o o p
does n o t h a v e c o n t i n u i t y ,
w h e n t h e LED is illuminated, which
indicates no ozone production.
HI TEMP HI TEMP
AIR PREP
DRYER 1
HI TEMP 1 HV DRIVE 2
HV DRIVE 2 HI TEMP 2
EXT LOOP
HI TEMP 2
EXT LOOP
AIR PREP
DRYER 1
DRYER 2
HIGH The High Temp LED will not be
TEMP illuminated during normal operation. If
the ozone generator’s internal
temperature is in excess of 150
˚
F the
DRYER 2
High Temp LED will illuminate,
which will also discontinue ozone
production.
AIR CD10/AD and CD12/AD Only: The
PREP Dryer Timer LED will flash
continuously during normal operation
and indicates that the dryer timer cycle
is operating correctly.
DRYER 1 CD10/AD and CD12/AD Only:
DRYER 1 LED will be illuminated
when dryer chamber #1 is heating.
DRYER 2 CD10/AD and CD12/AD Only:
DRYER 2 LED will be illuminated
when dryer chamber #2 is heating.
Note: There is a 30 minute period where Dryer #1 and Dryer #2 are off. This is normal. The dryers are in
a cool down phase before switching.