Corporate
800.882.8854
27
After the system is plumbed, wired correctly, and the time / date has been set leaving the
3 phase and single phase breakers in the control box on with the door closed..... Turn
the disconnect switch to the on position (see photo below). This will turn on power to the
control box which will initiate the Touch Screen and the PLC. From this point forward, the
control box will not require opening unless an internal problem occurs.
Please note:
If the HMI Touch Screen does not initiate, open the control box and verify
that the 110V wiring is terminated and the single pole breaker in the control box
and the one from the breaker is on. If power is verified and there is still no visible activity
on the HMI Touch Screen screen - turn to the Troubleshooting section or contact PurWater
technical support.
Turn the disconnect
switch clockwise from
the OFF position (left)
to the ON position
(right)
System Start-up
NOTE: In the event that
the Time / Date has not
been set, the message
on the right will be
displayed. The Reclaim
system must have this
set to proceed with start
up. The “OK” button
must be used at the end
of the procedure to save
the information.
Summary of Contents for PURWATER RECLAIM 3.0
Page 2: ...Corporate 800 882 8854 2...
Page 4: ...Corporate 800 882 8854 4...
Page 6: ...Corporate 800 882 8854 6...