Corporate
800.882.8854
46
Reclaim System Basics / Faults & Screen Information
Ths PurWater Reclaim System Manual has
covered the key points of getting the machine
running in the preceding pages. Customer
connections have been landed, time and
date have been set on the PLC, the system
has been tested in both “Hand” and “Auto”,
basic operation has been covered, and key
components identified. The “Gen 3” machine
will display system status as well as key
details should a fault occur and instructions
for troubleshooting leading to resolution.
The Reclaim is intended to be left in “Auto”
running 24 x 7. The screen description on the
right is a capture of the type of information
displayed when turned off.
The next screen is an example of what might
be seen should a fault of some sort occur in
Auto. As the screen states - Fault buttons are
in yellow and function buttons are in grey.
The next screen actually captures a “no
pump pressure fault” & directs the operator
to prime the system. Note that it shows there
is no VFD percentage indicating the VFD is
not running nor is there any pressure (PSI)
present. Priming the system as done on page
32 would be the immediate countermeasure
to try here. Touching the yellow “No pump psi
fault” will advanceto the next screen.
This screen is the descriptor that explains why
the fault occured & a reminder of the correct
procedure for priming the system.
Summary of Contents for PURWATER RECLAIM 3.0
Page 2: ...Corporate 800 882 8854 2...
Page 4: ...Corporate 800 882 8854 4...
Page 6: ...Corporate 800 882 8854 6...