Corporate
800.882.8854
26
Prior to System Start-up and
with the PurWater System
connected to facilities power…..
1. Open the Control Box, turn the
three pole breaker off &verify
that the single pole breaker is
on. Using a wrench or pliers,
rotate the main disconnect rod
clockwise to the “On” position.
Locate the PLC- the Time & Date
should be flashing as shown in
screen shot #1. Press the “ESC”
button.
2. “Stop” will appear highlighted
on the screen. as shown in
screen shot #2.
3. Use the Down Arrow Key and
scroll to “Setup” as shown in
screen shot #3. Press the OK
button.
4. Again, using the Down Arrow
Key, scroll to “Clock” as shown
in screen shot #4 and press the
OK button.
5. Again, using the Down Arrow
Key, scroll to “Set Clock” as
shown in screen shot #5 and
press the OK button.
6. Use the Right Arrow Key and
scroll through the Time and Date
using the Up / Down Arrow Keys
to change and set the numbers.
Note that miltary time is
required. Ex: 1pm = 13:00. When
complete, press ESC 3 times to
return to the Initial Blue Screen
with correct Time and Date.
7. Rotate the disconnect rod
counter-clockwise to the off
position. Leave the single pole
breaker on. Flip the three pole
breaker from the off to the on
position. Close the Control Box
Door & tighten the screws in
upper & lower right hand
corners.
8. Continue with System Start-up
Setting the Time and Date on the PLC
NOTE
THE PROCEDURE ON THIS PAGE WILL
WORK ON ALL “GEN 3” SYSTEMS BUT
IT IS THE ONLY OPTION FOR”PRE
2020” RECLAIM SYSTEMS OR THOSE
WITHOUT A TOUCH SCREEN HMI.
Summary of Contents for PURWATER RECLAIM 3.0
Page 2: ...Corporate 800 882 8854 2...
Page 4: ...Corporate 800 882 8854 4...
Page 6: ...Corporate 800 882 8854 6...
