PRONAR ZKP800, Operator'S Manual, Page: 67 / 102

SECTION 4 Pronar ZKP800
4.19
In order to disconnect the rotary rake from the tractor proceed as follows:
•
lower the left and right support (5) and secure them with cotter pins (6),
•
set the rotary rake using three-point linkage until supports (5) fully rest on the
ground,
•
place chocks under rotary rake wheel.
wheel chocks shall be so placed that one is in front of the wheel and
the second is behind it,
•
switch off tractor engine and remove key from ignition,
•
reduce residual pressure in the hydraulic system by movements of appropriate
lever controlling the tractor's hydraulic circuit,
•
disconnect hydraulic lines and place them on line bracket (4),
•
disconnect PTO shaft and place it on bracket (2),
•
disconnect lower pins of the rotary rake and drive tractor away.
DANGER
Do NOT use the securing chains to support the shaft while machine is parked or when
transporting the machine.
Disconnection of PTO shaft is not necessary but taking it off is recommended. Turning sharp
corners, especially in field conditions may be hindered because of this. If the shaft is not
taken off, is essential to remember not to engage the PTO drive of the tractor during transport
travel.