PRONAR ZKP800, Operator'S Manual, Page: 27 / 102

SECTION 2 Pronar ZKP800
2.3
•
Any modification to the machine frees the manufacturer from any responsibility for
damage or detriment to health which may arise as a result.
2.1.2 HITCHING AND DISCONNECTING THE ROTARY RAKE
•
The rotary rake should be hitched to and transported with only such an
agricultural tractor which fulfils all the requirements of the Manufacturer (minimum
tractor power demand, required three-point linkage category etc.) – compare table
(1.1) AGRICULTURAL TRACTOR REQUIREMENTS.
•
Before hitching the machine to the tractor, check the technical condition of the
hitching system of the rotary rake and the tractor.
•
Before hitching the machine make certain that oil in external hydraulic system of
tractor may be mixed with the hydraulic oil of the rotary rake.
•
When connecting the hydraulic lines to the tractor, make sure that the tractor and
rotary rake hydraulic system are not under pressure. If necessary reduce residual
pressure in the system.
•
To attach the machine to the tractor only the rear three point linkage may be
used. After mounting the machine, check the safeguards.
•
Be especially careful when hitching the machine to the tractor or truck tractor.
•
When reversing the tractor, there must be nobody between the rotary rake and
the tractor.
•
To mount machine on tractor use only genuine pins and safeguard cotter pins.
•
Before using the rotary rake always check its technical condition. In particular
check the technical condition of the hitching system, drive system, mounting of
rakes and protective guards.
•
Rotary rake uncoupled from tractor must be supported by supports and secured
against rolling away by using wheel chocks or other elements without sharp
edges.
2.1.3 TRANSPORTING THE MACHINE
•
During travel on public roads comply with the road traffic regulations and transport
regulations in force in a given country, in which the rotary rake is used.