PRONAR ZKP800, Operator'S Manual, Page: 61 / 102

SECTION 4 Pronar ZKP800
4.13
DANGER
Raking arms should be dismantled and mounted with tractor engine turned off. Remove
the key from the ignition, ensure that unauthorised persons do not have access to the
tractor. Tractor shall be immobilised with parking brake.
4.5 ROTARY RAKE OPERATION
4.5.1 SETTING ROTARY RAKE IN WORKING POSITION
Rotary rake transported to the field must be set in appropriate working position. Preparing of
the machine for work must only take place exclusively on level and stable surface. Perform
the following actions in order to set the rotary rake in working position:
stop tractor and remove the key from the ignition, ensure that unauthorised
persons do not have access to the tractor,
immobilise tractor with parking brake,
set lifting cylinder valve (3) in open position I- figure (4.3),
release lock (2) by pulling cable (1) (figure (4.3)) and by operating the tractor's
hydraulic circuit, lower lifting arms with raking assemblies so that the wheels
touch the ground and set tractor's hydraulic circuit in float position,
If the raking arms (1) were dismantled, remount them by sliding them into arm
mount (2) and secure with cotter pin (3) – figure (4.4).
DANGER
Before setting the rotary rake in working position or transport position make sure that
there are no bystanders in the danger zone.