PRONAR ZKP800, Operator'S Manual, Page: 31 / 102

SECTION 2 Pronar ZKP800
2.7
•
When using the rotary rake and power take-off shaft, do not use PTO rotation
speed other than 540 rpm. Do NOT overload shaft and rotary rake and also
engage the clutch suddenly.
•
Do NOT go over and under the shaft or stand on it equally during work and also
when the rotary rake is parked.
•
Never use a damaged PTO shaft, it may cause an accident. A damaged shaft
must be repaired or replaced.
•
Make sure that shaft is covered when travelling on an uneven terrain.
•
Disconnected PTO shaft should be placed in the specifically prepared holder.
•
Do NOT use the securing chains to support the shaft while machine is parked or
when transporting the rotary rake.
2.1.6 MACHINE OPERATION
•
Before starting the rotary rake make sure that there are no bystanders (especially
children) or animals in the danger zone. The machine operator is obliged to
ensure proper visibility of the machine and the working area.
•
Do not enter the machine rotation and folding zone.
•
Before activating the rotary rake, always ensure that all the safety guards are in
good condition and in place. Damaged or incomplete sub-assemblies must be
exchanged for original new ones.
•
Before starting work, always check condition and correct attachment of
springtines on raking arms.
•
Take particular care while working near people and animals.
•
During windrowing use the correct working position.
•
While windrowing apply working speed recommendations.
2.1.7 CLEANING, MAINTENANCE AND REPAIRS
•
Repair, maintenance and cleaning work should be carried out with the tractor's
engine turned off and the ignition key removed.