PRONAR ZKP800, Operator'S Manual, Page: 58 / 102

Pronar ZKP800 SECTION 4
4.10
DANGER
When hitching, there must be nobody between the rotary rake and the tractor. When
hitching the machine, tractor driver must exercise caution and make sure that nobody is
present in the hazard zone.
Make sure that there is nothing and nobody inside the load box.
When connecting the hydraulic lines to the tractor, make sure that the tractor and rotary
rake hydraulic system are not under pressure.
4.4 TRANSPORTING THE MACHINE
For transport to place of work and back, set the rotary rake in transport position.
Disconnection of PTO shaft from tractor's PTO is recommended.
Setting the rotary rake in transport position
Four raking arms located on the outside of the raking assemblies can be
dismantled in order to reduce transport width and height of the machine.
In order to dismantle the raking arm, take out securing cotter
pin (2) and pull the raking arm out of its mount in the raking
assembly gear.
Place the raking arms in the seats on the main frame (3) and
secure them with cotter pins (2) - figure (4.2).
Set the locking valve (3) of lifting/lowering hydraulic cylinders in open position I
– figure (4.3).
Set the locking valves (4) and (5) of the raking width adjusting hydraulic
cylinders in closed position 0 – figure (4.3).
The raking arms and protective shields should be folded in
order to reduce total transport height of the machine.