Reference 6202-WA-DFNT-DFCM3
♦
ProLinx Gateway
Wireless EtherNet/IP to DF1 Master/Slave-3 ports
ProSoft Technology, Inc.
Page 167 of 190
February 2, 2009
Each command issued from the DF1 master contains a field that indicates the
location in the virtual database to be associated with the command. Care must
be taken when designing a system to be sure the read and write data regions for
the database do not overlap for a single device. The read area of one device can
overlap the write section of another device to transfer the data from one slave
device to another.
Command Function Codes
This section describes DFNT commands to be configured by the user.
Module Information Data
Device Information Data
1 2 3 4 5 6 7 8 9 10 11
Enable
Code
Internal
Address
Poll
Interval
Time
Count Swap
Code
Node
Address
Function
Code
Function Parameters
Function Code #1 - Protected Write (Basic Command Set)
Column
Parameter
Description
Parameter
1
Enable/Type Word
0=Disabled, 1=Continuous and 2=Conditional.
2
Virtual Database Address
This parameter defines the database address of the first
data point to be associated with the command.
3
Poll Interval
Minimum time in tenths of a second to wait before polling
with this command.
4
Count
Number of data word values to be considered by the
function.
5
Swap Type Code
Swap type code for command: 0=None, 1=Swap words,
2=Swap words & bytes and 3=swap bytes in each word.
6
Node Address
Address of unit to reach on the data highway.
7
Function Code = 1
Protected Write Function
8
Word Address
Word address where to start the write operation.
P1
9 to 11
Not Used
These fields are not used by the command. Values
entered in these columns will be ignored.
P2 to P4
This function writes one or more words of data into a limited area of the slave
device. This function should work on the following devices: 1774-PLC, PLC-2,
PLC-3, PLC-5 and PLC-5/250.
Function Code #2 - Unprotected Read (Basic Command Set)
Column
Parameter
Description
Parameter
1
Enable/Type Word
0=Disabled and 1=Continuous.
2
Virtual Database Address
This parameter defines the database address of the first
data point to be associated with the command.
3
Poll Interval
Minimum time in tenths of a second to wait before
polling with this command.
4
Count
Number of data word values to be considered by the
function.
5
Swap Type Code
Swap type code for command: 0=None, 1=Swap words,
2=Swap words & bytes and 3=swap bytes in each word.
6
Node Address
Address of unit to reach on the data highway.
7
Function Code = 2
Unprotected Read Function
8
Word Address
Word address where to start the read operation.
P1
9 to 11
Not Used
These fields are not used by the command. Values
entered in these columns will be ignored.
P2 to P4
Summary of Contents for 6202-WA-DFNT-DFCM3
Page 4: ......