ProLinx 6202-WA-DFNT-DFCM3, User Manual, Page: 152 / 190

6202-WA-DFNT-DFCM3 ♦ ProLinx Gateway Reference
Wireless EtherNet/IP to DF1 Master/Slave-3 ports
Page 152 of 190 ProSoft Technology, Inc.
February 2, 2009
Verify that the CIP radio-button is selected as the Communication Method . The
Path specifies the message path from the ControlLogix processor to the module.
In the example above, the path is from the processor to the Enet module (1756-
ENET module in slot 2), the 2 represents the Ethernet port on the 1756-ENET
module and the last portion of the path is the IP address of the DFNT module to
reach (192.168.0.75). More complex paths are possible if routing to other
networks using multiple 1756-ENET modules and racks. Refer to the Knowledge
Document 10803, Control Logix Gateway: Ethernet Communications for a full
discussion of Ethernet routing and path definition.
CIP Data Table Read
CIP data table read messages transfer data to the ControlLogix processor from
the DFNT module. An example rung used to execute a read command is shown:
The Message Configuration dialog box must be completed to define the data
set to transfer to the processor from the module. An example of the dialog box
follows: