PROFACE PL-B900 Series, User Manual

Page: 77 / 98

System Setup
5-15
PL B900/B910 Series Users Manual
! IDE Primary Slave PIO
Designates the Slave Drive's Operation Mode. Only after the "Internal PCI/
IDE" has been set to [Primary] can these IDE Primary Slave PIO settings be
entered. The selections available are [Auto], [Mode0], [Mode1], [Mode2],
[Mode3], and [Mode4]. When using the CD-ROM unit, set this to "Mode 2".
! IDE Primary Master UDMA
Designates the Master Drive's UDMA Operation Mode. The two selections
available are [Auto] or [Disabled]. The [Auto] selection is factory set and
recommended for most users.
When using the CD-ROM unit, or a PL-B910/PLB911
(PL-B910 Series) unit, set this to
[Disabled]
.
! IDE Primary Slave UDMA
Designates
the Slave Drive's UDMA Operation Mode. The two selections available are
[Auto] or [Disabled]. The [Auto] selection is factory set and recommended for
most users.
When using the CD-ROM unit, or a PL-B910/PLB911 (PL-B910 Series) unit,
set this to
[Disabled]
.
! Onboard FDC Controller
Designates whether the PL's FDD(Floppy Disk Drive) controller is used or not.
The two selections available are [Disabled] or [Enabled]. The [Enabled] selection
is factory set and recommended for most users.
! Onboard Serial Port1
Designates the PL's Serial Port1 address setting. The selections include
[Disabled], [Auto], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4] or [2E8/IRQ3]. The
[3F8/IRQ4] selection is factory set and recommended for most users.
! Onboard Serial Port2
Designates the PL's Serial Port2 address setting. The selections include
[Disabled], [Auto], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4] or [2E8/IRQ3]. The
[2F8/IRQ3] selection is factory set and recommended for most users.
! UR2 Mode
Designates the IR function used by the PL's onboard I/O chip. The selections
include [Standard], [Sharp IR], [IrDA SIR]. The [Standard] selection is factory
set and recommended for most users. When serial port 2 is used for RS-232C
communication, and the [standard] option's PL-IR100 selection is used, set this
item to [IrDA/SIR].
!
Onboard Parallel Port
Selects the PL Parallel Port 1's I/O Address. The selections include [Disabled],
[3BC/IRQ7], [378/IRQ7] or [278/IRQ5]. The [3BC/IRQ7] selection is factory set
and recommended for most users.
! Parallel Port Mode
Here, the parallel port's operation mode can be selected ([SPP], [EPP1.7],
[EPP1.9], [ECP], or [ECP
+
EPP]). Normally, [SPP] is used and recommended
for most users. When either [ECP] or [ECP+EPP] is selected, the [ECP Mode
Use DMA] setting can be used.
! ECP Mode Use DMA
Designates the ECP mode's DMA channel. [1] and [3] are available selections,
however, this item can be set only when the Parallel Port Mode is set to either
[ECP] or [ECP+EPP].