PROFACE PL-B900 Series, User Manual

Page: 67 / 98

System Setup
5-5
PL B900/B910 Series Users Manual
! Boot Up Floppy Seek
Designates if the floppy disk drive installation check is used or not. The
available selections are [Disabled] and [Enabled]. [Enabled] is factory set
and recommended for most users.
! Boot Up NumLock Status
Designates the condition of the NumLock key at startup. The two
selections are either [On] or [Off]. The [On] selection is factory set and
recommended for most users.
! Boot Up System Speed
Designates the speed of CPU. [High] is factory set and recommended for
most users. The other available selection is [Low].
! Gate A20 Option
The two selections available are [Fast] and [Normal]. When [Normal] is selected,
Keyboard Control is used for Gate A20 control. When [Fast] is selected, the
Chipset is used. The [Fast] selection is factory set and recommended for most
users.
! Memory Parity / ECC Check
Designates if a Parity Check is used for Parity Memory. The two selections
available are [Disabled] and [Enabled]. The [Enabled] selection is factory
set and recommended for most users.
!
Typematic Rate Setting
Designates the repeat mode for characters on the keyboard. The selections
[Disabled] and [Enabled] are available. [Disabled] is factory set and
recommended for most users.
! Typematic Rate (Chars/Sec)
When [Enabled] is selected on [Typematic Rate Setting], it designates the
actual rate (the number of repeating characters per second).
[6],[8],[10],[12],[15], [20],[24] and [30] are the available selections.[6] is
factory set.
! Typematic Delay (Msec)
When [Enabled] is selected on [Typematic Rate Setting], it designates the
time until repetition of a character starts. The unit is mili-second (msec).
The available selections are [250],[500],[750]and [1000]. [250] is factory
set.
! Security Option
Designates the location of the Password Entry. The selection [Setup] is for
BIOS setup,and the other selection [System] is for both BIOS setup and
Start up.When the [Supervisor Password] or [User Password] has not
been designated, this setting is disabled. [Setup] is factory set and
recommended for most users.
Choose either the "Supervisor Password" or the "User Password" from the Pass-
word menu.
! !
! !
! PCI/VGA Palette Snoop
When the PCI/VGA and the MPEG ISA/VESA VAG cards are both used,
this setting is set to [Enabled]. In all other cases, this should be set to
[Disabled]. The [Disabled] selection is factory set and recommended for
most users.