PROFACE PL-B900 Series, User Manual

Page: 74 / 98

System Setup
5-12
PL B900/B910 Series Users Manual
ROM PCI/ISA BIOS(2A5LEU1C)
SYSTEM MONITOR UTILITY
AWARD SOFTWARE, INC.
Selecting SYSTEM MONITOR UTILITY menu item displays the following screen.
! PCI #2 Access #1 Retry
Enables or disables the PCI "2 Access #1 Retry feature. [Enabled] and
[Disabled] are available. The [Disabled] setting is factory set and
recommended for most users.
! PCI IRQ Activated by
Designates the interrupt method used for the unit's PCI slots. [Level] or
[Edge] can be used. [Level] is factory set and recommended for most
users.
! Assign IRQ For USB
Designates if the interrupt is allocated for USB equipment or not.
[Enabled] and [Disabled] are available. The PL-B910/PL-B911 (PL-
B910 Series) units should be set to [Enabled].
5. 2. 8 SYSTEM MONITOR UTILITY
5. 2. 6 LOAD BIOS DEFAULTS
5. 2. 7 LOAD SETUP DEFAULTS
Selecting "LOAD BIOS DEFAULTS" calls up the menu used to enter the mini-
mum level system settings. It is normally not used.
CPU Warning Temperature : Disabled
System Warning Temp. : Disabled
Power FAN : Tolerance : Disabled
CPU FAN
: Tolerance : Disabled
IN0(Vcore) : Tolerance : Disabled
IN2( 3.3V) : Tolerance : Disabled
IN3( 5V) : Tolerance : Disabled
IN4( 12V) : Tolerance : Disabled
IN5( -12V) : Tolerance : Disabled
IN6( -5V) : Tolerance : Disabled
ESC: Quit ↑↓→← :Select Item
F1 : Help PU/PD/+/-:Modify
F5 : Old Values (Shift)F2:Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
* The above settings are factory settings.
With a PL-B900, PL-B901 (PL-B900 Series) unit, selecting "Load Setup Default"
will revert the unit to the original factory settings.
With a PL-B910, PL-B911 (PL-B910 Series) unit, after selecting "Load Setup
Default", be sure to change the following settings to revert the unit to the original
factory settings.
• CHIPSET FEATURES SETUP Change [On Chip USB] to [Enabled].
Change [USB Keyboard Support] to [Enabled].
• PNP/PCI CONFIGURATION Change [Assign IRQ for USB] to [Enabled].
• INTEGRATED PERIPHERALS Change [Onboard Serial Port 4] to [Disabled].
Change [IDE Primary Master UDMA] to [Disabled].
Change [IDE Primary Slave UDMA] to[Disabled]