PROFACE PL-B900 Series, User Manual

Page: 69 / 98

System Setup
5-7
PL B900/B910 Series Users Manual
! SDRAM Cycle Length
Designates the length of the cycle time of SDRAM. The available
selections are [3] and [2]. [3] is factory set and recommended for most
users.
! DRAM Read Pipeline
Designates if the DRAM performs the pipeline read. The available
selections are [Enabled] and [Disabled], [Enabled] is factory set and
recommended for most users.
! Sustained 3T Write
Designates if the DRAM performs the write back and the write through in
the secondary cache.The available selections are [Enabled] and [Disabled].
[Enabled] is factory set and recommended for most users.
! Cache Rd+CPU Wt Pipeline
Designates the length of time of waiting for the cache performance. The
available selections are [Enabled] and [Disabled]. [Enabled] is factory set
and recommended for most users.
! Cache Timing
Designates the access speed of the cache. The available selections are
[Fast] and [Fastest]. [Fast] is factory set and recommended for most users.
! Video BIOS Cacheable
Designates if the cache performs on the Video BIOS. The available
selections are [Enabled] and [Disabled]. [Enabled] is factory set and
recommended for most users.
! System BIOS Cacheable
Designates if the cache performs on the System BIOS. Using System BIOS
speeds up the program operation. The available selections are [Enabled]
and [Disabled]. [Enabled] is factory set and recommended for most users.
!
Memory Hole At 15Mb Addr.
Designates if the memory hole 15MB to 16MB is allocated to the buffer
memory for the ISA bus card. The available selections are [15M-16M] and
[Disabled]. [Disabled] is factory set and recommended for most users.
! On Chip USB
Used for USB type peripheral equipment. The available selections are
[Enabled] and [Disabled]. The PL-B910/PL-B911 (PL-B910 Series) units
should be set to [Enabled].
! USB Keyboard Support
If the "On Chip USB" selection is enabled, this setting designates if a USB
type keyboard can be used. The available selections are [Enabled] and
[Disabled]. The PL-B910/PL-B911 (PL-B910 Series) units should be set to
[Enabled].