15-12
Redundancy (Switch 8212zl)
Using Redundant Management
Enabling and Disabling Fabric Modules
The fabric modules can be enabled or disabled even if they are not present in
the switch. You cannot disable both fabric modules at the same time; one must
be enabled. Use this command to enable or disable the redundant fabric
modules. Disabling one fabric module reduces the overall switching capacity
of the 8200zl series switches. On some networks where network utilization is
less than 50%, you may not notice any degradation of performance.
Figure 15-7. Example of Disabling a Fabric Module
Syntax:
redundancy fabric-module [1 | 2] [enable | disable]
Allows enabling or disabling of fabric modules. You cannot
have both fabric modules disabled at the same time.
Default: Both fabric modules are enabled.
ProCurve(config)# redundancy fabric-module 2 disable
ProCurve(config)# show redundancy
Settings
--------
Mgmt Redundancy : enabled
Statistics
----------
Failovers : 0
Last Failover :
Slot Module Description Status SW Version Boot Image
---- ---------------------------------------- -------- ---------- ----------
1 ProCurve J9092A Management Module 8200zl Active K.12.XX Primary
2 ProCurve J9092A Management Module 8200zl Standby K.12.XX Primary
1 ProCurve J9093A F2 Fabric Module 8200zl Enabled
2 ProCurve J9093A F2 Fabric Module 8200zl Disabled
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 12 Monday, January 28, 2008 10:04 AM