10-11
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
•
This switch only supports revision B and above
transceivers. Check: www.hp.com/rnd/device_help/
2_inform for more info.
•
Self test failure.
•
Transceiver type not supported in this port.
•
Transceiver type not supported in this software
version.
•
Not a ProCurve Transceiver. Please go to:
www.hp.com/rnd/device_help/2_inform for more info.
Enabling or Disabling Ports and Configuring Port Mode
You can configure one or more of the following port parameters. Refer to table
10-1 on pages 10-3 through 10-4.
Note that in the above syntax you can substitute an “
int
” for “
interface
”; that
is:
int <
port-list
>
.
The 10/100 auto-negotiation feature allows a port to establish a link with a port
at the other end at either 10 Mbps or 100 Mbps, using the highest mutual speed
and duplex mode available. Only these speeds are allowed with this setting.
For example, to configure port C5 for auto-10-100, enter this command:
ProCurve(config)# int c5 speed-duplex auto-10-100
To configure ports C1 through C3 and port C6 for 100Mbps full-duplex, you
would enter these commands:
ProCurve(config)# int c1-c3,c6 speed-duplex 100-full
Similarly, to configure a single port with the above command settings, you
could either enter the same command with only the one port identified, or go
to the
context level
for that port and then enter the command. For example,
to enter the context level for port C6 and then configure that port for 100FDx:
Syntax:
[no] interface
<
port-list >
[< disable | enable >]
Disables or enables the port for network traffic. Does not
use the
no
form of the command. (Default:
enable
.)
[speed-duplex < auto-10 |10-full | 10-half | 100-full | 100-half |auto| auto-
100 | 1000-full >]
Specifies the port’s data transfer speed and mode. Does
not use the
no
form of the command. (Default:
auto
.)
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 11 Monday, January 28, 2008 10:04 AM