Printek FormsPro 4000se Series, Operator'S Manual

Page: 23 / 127

G E T T I N G S T A R T E D
15
2. While you pull outward on this panel, lift the front of the unit to
expose the paper tractors. The top of the unit will support itself in
the up position while you load paper.
3. To load paper or forms, open the door on each tractor and
position the holes in the paper over the pins in the tractors; then
close the doors.
4. If the tractors are not set at the proper width for the paper you are
loading, simply move the lever beside the right tractor door to the
open position and the tractor will slide sideways.
5. The tractors should be spaced far enough apart so that the paper
does not buckle in the center, but not so tight that the pins in the
tractors distort the holes in the paper.
Note: The left tractor position is not adjustable. If it is necessary to
adjust where printing begins, refer to “
Aligning Print
” in the
“
DAILY OPERATION
”
section of this manual.
A properly installed form is shown below.
Note: The form does not extend above the top of the tractor doors.