Printek FormsPro 4000se Series, Operator'S Manual

Page: 44 / 127

D A I L Y O P E R A T I O N
36
Aligning Print
When a new form is loaded into the printer for the first time , it may be
necessary to adjust where printing begins. This depends upon how the
software that controls the printing was written. If the software was written
to perform its own character and line spacing relative to the edges of the
form, then adjustment may not be necessary. If the print position needs to
be adjusted, the following discussion will describe how this is accomplished.
Note that the alignment for the selected form is permanently stored in the
printer’s memory and does not have to be readjusted each time the form is
loaded.
To align print on a particular form, select that form with the
FORM SELECT
button and then press either of the
ALIGN
buttons. If the form selected were
named “Invoices”, the display would now show the following.
Aligning Print
On INVOICES
After a short time, the display would change to show that you can now
MOVE PRINT
left or right. Be sure to remember that you are moving
where the print is placed on the page.
MOVE
Left/Right
PRINT
←
0.00”
→
The
VALUE
buttons will move the print left or right in 1/100
th
inch
increments. Note that the left and right arrows will change according to
which way the print has been moved from the normal print position. The
maximum distance print may be moved is 9.99 inches in either direction.
To move the print vertically on the page, press either of the
ALIGN
buttons
and the display will change to the following.